Ash Les Paul: Setting the Neck

Today I got back to the Ash Les Paul. I was able to level, re-crown and polish the frets for a sexy look and a super-smooth action! I've previously waited until after the neck was attached to do the frets, and on the whole my experiences have been mixed. Previously I have found it hard to re-crown frets on the bridge end of the neck for some models when the fretboard is close to the body. I decided to try leveling and re-crowning the frets before gluing this time. The frets turned out ok, but trying to hold on to the neck whilst sanding and filing was a bit of a bitch. I guess I need a couple of vices here on the work-bench!

Anyway, with the frets done, I carried on immediately and glued the neck. Fingers crossed that I did everything correctly! It all looks great - the E strings run nice and straight up the neck and are sitting almost on the top of the 22nd fret. Should make for a nice low action! However, in the back of my mind I couldn't shake a little voice telling me that I didn't use enough glue. I had all the surfaces covered, but there wasn't much squeeze out. But that's a good thing right?? Oh well, time will tell!

Titebond and a clamp does a set-neck make!

The whole shebang. She's looking the goods!

E strings sitting nice and straight up the neck and almost resting on the 22nd fret.

I'm very excited about getting this little baby completed, and she's actually starting to look like something now! Next step is to get the control cavity shielded and to solder on the ground wire. I don't think I'll shield the pickup cavities this time around as I've read comments out there on the inter-web saying that shielding here cuts the highs from the signal? Am I right in thinking this? Let me know your opinions out there!

Once the clamp comes off the neck, I'll be waxing the fretboard with Dingotone guitar wax and then starting on the electronics. Stay tuned!