With the burst looking great on the front and back of the Starcaster build, the more I looked at it, the less pleased I was with how the dyed sides looked. It was time to make a tough decision. If you remember from my last update on this project, the dye didn't take on the sides in a number of places where the craftsmanship was exceedingly average. Looking at it again, I decided to apply a solid colour to the sides to cover over these patches. I re-filled the entire surface with Timbermate, applied some primer, and sprayed two coats of MTN94 "RV-99 Marron Glace" over it all. Thankfully my masking was good and none of the primer or colour made it onto the front or back.
 |
| Stain would have been better, but MTN94 has covered the bad workmanship. |
I'm really glad that I made the decision. The end result is pretty damn good I reckon - much better than the stain over those shoddy patches. I'm really liking how this baby is now shaping up. I'm in a bit of a quandry about what colour to stain the neck, as I usually go with a colour to match the sides. That's not going to happen in this case - there's no way I'm going to spray the neck a solid colour as well. Maybe Amber with a bit of a dirty Tobacco burst, but I'm still thinking.
No comments:
Post a Comment